HW #5 - Interpolation Elevation Data

The objective of this assignment is to interpolate a set of MODFLOW layer elevations using the scatter point tools in GMS.  We will start with an existing MODFLOW model:

Note: You may work in pairs on this assignment.

Do the following:

1) Download and unzip the following project: interpcase.zip

2) Open the project within GMS.

This is a partially completed one layer MODFLOW model of a site.  However, we need to interpolate the top and bottom elevations and a set of starting heads.

3) Use the tops.sp2 scatter point set to interpolate to the MODFLOW top elevation array.

4) Use the bottoms2.sp2 scatter point set to interpolate to the MODFLOW bottom elevation array.

5) Use the Data Calculator to create a data set on the tops.sp2 scatter point set representing the top elevations minus 10 feet. Call your new data set shead.  Interpolate this data set to the MODFLOW Starting Heads Array.

Zip up all files associated with your project.  Log in to your student account to upload your zip archive.